|
Static Control on a Higher Level |
|
Static Control on a Higher Level |
SELECT
ANOTHER ESD flooring MATERIAL
ElectraFloor ESD flooring Conductivity and
Specifications The following data represents electrical test results after installation at two locations in separate parts of the United States Testing was performed in accordance with industry accepted standards of EOS ESD 7.1. These floors were installed "on grade" and on concrete. Further, the floors were grounded utilizing standard parameters shown in How to Ground your new ESD Floor. Your results may vary due to substrate, substrate conditions and environmental conditions prevalent in your location. As is the case with many of the modern ESD Vinyl's, ElectraFloor is designed to work as a system in conjunction with C-2000, US C-2000R or URAS conductive adhesive. When testing uninstalled, the static dissipative material (without the adhesive) will show a slightly higher resistance value than those posted in our electrical specifications (prevalent only with the static dissipative materials). ElectraFloor static dissipative is designed with a built in resistance value that provides added safety to employees that may come into contact with higher voltage / amperage power sources. This added resistance has shown minimal effect in it's ability to control ESD. Electrical Testing by United ESD
|
Go
back to last page
